MirBSD manpage: lge(4)

LGE(4)                     BSD Programmer's Manual                      LGE(4)


     lge - Level 1 LXT1001 NetCellerator PCI gigabit ethernet adapter driver


     lge* at pci? dev ? function ?


     The lge driver provides support for various NICs based on the Level 1
     LXT1001 NetCellerator gigabit ethernet controller chip, including the

     •   SMC TigerCard 1000 (SMC9462SX)
     •   D-Link DGE-500SX

     These NICs are capable of 1000Mbps speeds over fiber optic cable. The
     LXT1001 also supports a GMII port for use with 10/100/1000 copper PHYs,
     however there aren't currently any NICs on the market that use this

     The LXT1001 supports TCP/IP checksum offload for receive and VLAN-based
     filtering as well as a 64-bit multicast hash filter. It also supports
     jumbo frames, which can be configured via the interface MTU setting.
     Selecting an MTU larger than 1500 bytes with the ifconfig(8) utility con-
     figures the adapter to receive and transmit jumbo frames. Using jumbo
     frames can greatly improve performance for certain tasks, such as file
     transfers and data streaming.

     The lge driver supports the following media types:

     autoselect   Enable autoselection of the media type and options. The user
                  can manually override the autoselected mode by adding media
                  options to the appropriate hostname.if(5) file.

     1000baseSX   Set 1000baseSX operation over fiber optic cable. Both full-
                  duplex and half-duplex modes are supported.

     The lge driver supports the following media options:

     full-duplex  Force full duplex operation.

     half-duplex  Force half duplex operation.

     For more information on configuring this device, see ifconfig(8).


     lge%d: couldn't map memory  A fatal initialization error has occurred.

     lge%d: couldn't map ports  A fatal initialization error has occurred.

     lge%d: couldn't map interrupt  A fatal initialization error has occurred.

     lge%d: no memory for softc struct!  The driver failed to allocate memory
     for per-device instance information during initialization.

     lge%d: failed to enable memory mapping!  The driver failed to initialize
     PCI shared memory mapping. This might happen if the card is not in a
     bus-master slot.

     lge%d: no memory for jumbo buffers!  The driver failed to allocate memory
     for jumbo frames during initialization.

     lge%d: watchdog timeout  The device has stopped responding to the net-
     work, or there is a problem with the network connection (cable).


     arp(4), ifmedia(4), intro(4), netintro(4), pci(4), vlan(4),
     hostname.if(5), ifconfig(8)

     Level 1 LXT1001 Programming Manual,


     The lge device driver first appeared in OpenBSD 3.0.


     The lge driver was written by Bill Paul <william.paul@windriver.com>.

MirBSD #10-current               May 30, 2001                                1

Generated on 2021-12-07 11:07:08 by $MirOS: src/scripts/roff2htm,v 1.103 2021/01/23 20:24:35 tg Exp $ — This product includes material provided by mirabilos.

These manual pages and other documentation are copyrighted by their respective writers; their sources are available at the project’s CVSweb, AnonCVS and other mirrors. The rest is Copyright © 2002–2021 MirBSD.

This manual page’s HTML representation is supposed to be valid XHTML/1.1; if not, please send a bug report — diffs preferred.